GPS-Cover 64

This cover made out of PCB-material is attached directly to the MKGPS board.
The side panels are easily connected using solder.
This is also the ground plane for the GPS antenna. This increases the GPS reception. The signal to noise ratio for the rest of the electronics in MikroKopter is increased.
Another positive effect is to protect the altitude (pressure) sensor against (propeller)-wind and light.

Technical Data

• PCB-Material: 1 layer, 0.5 mm thick
• Soldermask on both sides Black
• Dimensions of the finished hood: 50x50mm to 120x120mm with a height of 64mm
• Weight: 35g

scope of delivery

• * 8 PCB parts to construct the sides of a cap

Advice

• the MKGPS board (order separately) is the 'cap' - alternative cover part also available separately
• In the side panels LEDs can be mounted
• The hood is designed for quadrocopters. In other variants it could not match

Links

• Description in Forum